Problems When Installing an Industrial Circuit Breaker

circuit breaker Installation

There are a few problems that can occur during the installation process for iindustrial circuit breakers. Knowing about the potential issues and knowing what to do if the problem is encountered is key in performing any type of work with electricity and industrial circuit breakers.

Possible Problems When Installing an Industrial Circuit Breaker

Some of the problems that can be encountered when installing an industrial circuit breaker include a circuit overload, overheating of the circuit breaker, a ground-fault, an arc-fault, and a short circuit. Knowing about these potential problems before working with the industrial Circuit Breakerscan help prevent dangerous situations and damage to the electrical system.

A circuit overload can occur if the industrial circuit breaker is connected to a heavier electrical load than it can handle. If there is a poor connection to the industrial circuit breaker then it can lead to overheating. A ground-fault occurs when the current is misdirected from the ground wire. A spark on the circuit is caused by an arc-fault. A fault on a circuit can cause a high current which then causes a short circuit to occur on the industrial circuit breaker.

Troubleshooting When Installing an Industrial Circuit Breaker

Knowing about the potential problems comes first followed by what to do to fix the problem. Make sure to have all of the right tools on hand to be prepared for any type of situation when installing industrial circuit breakers. The industrial circuit breaker should be tested to make sure the defective one is correctly being replaced. Simply push the test button on the industrial circuit breaker. If it trips then it is working properly and if it does not then it needs to be replaced with a new industrial circuit breaker.

What should be done when an industrial circuit breaker trips? The job is not complete just by flipping the switch. Testing still has to take place in order to make certain that the current problem is fixed and to help prevent issues from reoccurring. A voltmeter is used to test the industrial circuit breaker. If the industrial circuit breaker can be reset easily without tripping again then an arc-fault, overload, or overheated breaker most likely occurred. A short circuit or ground-fault may have occurred if the industrial circuit breaker trips again shortly after it has been reset.

An industrial circuit breaker may have to be replaced if an arc-fault took place and tripped the circuit. An arc-fault or ground-fault may have taken place if the circuit did not trip. To find out, a ground-fault circuit interrupter (GFCI) can be added. There was a ground-fault if the GFCI does not hold or an arc-fault if the GFCI does hold.

Installing an industrial circuit breaker can be difficult, especially if one is not entirely familiar with the process. Before taking any action, learn everything there is to know about the tools that are needed, the potential problems that can occur, and what to do if and when a problem arises when installing industrial circuit breakers. Of course, if there are any problems then call an electrician to come take care of the problem.